Tc-helicon VoiceLive 2 User manual Bedienungsanleitung PDF herunterladen (Seite 63)

Overview

The Harmony block in VoiceLive 2 produces up to 8

harmony voices and is the home of the Choir effect.

IMPORTANT NOTE: The parameters available on the

HARMONY Tab and their organization differs depending

on the value of the NATURALPLAY parameter at the

bottom of the tab.This section begins by describing the

most common NATURALPLAY harmony mode: AUTO

INPUT SENSE. Following the parameter descriptions for

AUTO INPUT SENSE, exceptions and differences for

the other NATURALPLAY modes are listed.

STYLE

Use the soft knob assigned to this parameter to choose

a Harmony style you like. Styles configure useful settings

to pre-programmed values to allow you to make

changes quickly. The selection of styles will change

depending on the setting of the NATURALPLAY

parameter.

LEVEL

Sets the level for the overall Harmony effect in the

current preset.

V1 to V4 VOICING

Here you set the pitch shift intervals of voices 1 through

4 relative to your input pitch. The names of the intervals

change depending on NATURALPLAY mode. In the two

MIDI NOTES modes, the VOICING parameters

disappear entirely. The options start at the lowest

harmony interval and go the highest.

V1 to V4 LEVEL

The four knobs control the relative volume of each

voice.This is also where voices are turned on an off.The

range of values goes from Off to 0 dB (Full).Typically all

voices are set at the same level unless you want to

highlight or minimize a particular voicing interval.

V1 to V4 GENDER

Each voice has its own timbre adjustment in the form of

the GENDER control.Values below 0 lend each voice a

The Edit Menu: HARMONY Tab

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 104 105

Keine Kommentare

Tc-helicon VoiceLive 2 User manual Bedienungsanleitung Seite 63